Try 300-815 Free Now! Real Exam Question Answers Updated [Dec 17, 2024]
Get Ready to Pass the 300-815 exam with Cisco Latest Practice Exam
NEW QUESTION # 43
An engineer Is configuring a Cisco Unified Border Element. The SIP ITSP requires a DNIS of 10-digits and DTMF tones sent in the RTP stream on the outbound leg of a call. Which code completes this configuration?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION # 44
A user in location X dials an extension at location Y.
The call travels through a QoS-enabled WAN network, but the user experiences choppy or clipped audio. What is the cause of this issue?
- A. ptime mismatch
- B. codec mismatch
- C. missing Call Admission Control
- D. phone class of service issue
Answer: C
NEW QUESTION # 45
An engineer has temporarily disabled toll fraud prevention for SIP line calls on a Cisco CME12.6x and must enforce security and toll fraud prevention for the SIP line side on Cisco Unified CME.
Which configuration must be used to start this process?
- A. voice service voip
ip address trusted authenticate - B. voice service voip
enablo ip address trust authentication - C. voice service voip
ip address trusted list - D. voice service voip
enable ip address trust list
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmead m/cmetoll.html
NEW QUESTION # 46
An engineer is troubleshooting local ringback on a Cisco SIP gateway. The gateway is not ignoring the SIP 180 response with SDP from the service provider, and the far end device is sending the 180 with SDP to play ringback from the IP address specified m the SDP.
Which configuration change must be made on the gateway to resolve the issue?
- A. Router(con(-voi-serv)# no disable-early-media 180
- B. Router(config-sip-ua)# no disable-early-media 180
- C. Router(config-sip-ua)# disable-early-media 180
- D. Router(conf-voi-serv)# dlisable-early-media 180
Answer: C
NEW QUESTION # 47
An organization has decided to implement hunt groups to help with the distribution of calls between different members. The administrator must configure hunt groups on Cisco UCM. In the configuration, at which step does an administrator have the option to configure a distribution algorithm (top down, circular, longest idle time, broadcast)?
- A. hunt list
- B. route list
- C. hunt group
- D. line group
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/cucm_ b_system-configuration-guide-1201/cucm_b_system-configuration-guide-
1201_chapter_010101.html
NEW QUESTION # 48
In Cisco Unified Communications Manager globalized call routing is implemented and must confirm that it is correctly implemented without making a call. Which tool do you use for verification?
- A. Dialed Number Analyzer
- B. SDI trace
- C. SDL trace
- D. Real-Time Monitoring Tool
Answer: A
NEW QUESTION # 49
Where is the dtmf-relay command configured on Cisco Unified Border Element?
- A. in global SIP configuration
- B. in the voice-class VoIP configuration
- C. in the VoIP dial peer
- D. in the VoIP or POTS dial peers
Answer: C
Explanation:
Section: Cisco Unified Border Element
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book/dtmf- relay.html
NEW QUESTION # 50
When the services key is pressed Cisco Extension Mobility does not show up.
What is the cause of the issue?
- A. Cisco Extension Mobility is not enabled in the Phone Configuration Window (Device > Phone)
- B. Cisco Extension Mobility Service is not running.
- C. The phone is not subscribed to Cisco Extension Mobility Service.
- D. The URL configured for Cisco Extension Mobility is not correct.
Answer: C
NEW QUESTION # 51
Refer to the exhibit. An administrator just implemented SIP trunking on their Cisco UCM and reports that calls using the SIP trunk are using Media Termination Point resources unnecessarily.
Which action resolves the issue?
- A. Disable SIP Rel1XX Options.
- B. Change to a range that does not result in MTP.
- C. Change DTMF Signaling Method to "RFC 4733".
- D. Change DTMF Signaling Method to "No Preference".
Answer: B
NEW QUESTION # 52
Refer to the exhibit.
ILS has been configured between two hubs using this configuration. The hubs appear to register successfully, but ILS is not functioning as expected. Which configuration step is missing?
- A. A password has never been set for ILS.
- B. Trust certificates for ILS have not been installed on the clusters
- C. Use TLS Certificates must be selected.
- D. The Cluster IDs have not been set to unique values
Answer: D
NEW QUESTION # 53
Which configuration element of a hunt group allows for changing Calling Party Transformations settings?
- A. hunt list
- B. route group
- C. hunt pilot
- D. line group
Answer: C
Explanation:
Reference:
https://community.cisco.com/t5/ip-telephony-and-phones/call-alerting-on-hunt-group-as-shared- line/td-p/2658015
NEW QUESTION # 54
An engineer is configuring a Cisco Collaboration system for SIP endpoints and must enable Survivable Remote Site Telephony for these endpoints. Which code completes this configuration on the SRST gateway?
- A. call-manager-fallback
max-conferences 8 gain -6
ip source-address 10.10.10.100 port 2000
max-ephones 100
max-dn 200 - B. telephony-service
max-conferences 8 gain -6
ip source-address 10.10.10.100 port 2000
max-ephones 100
max-dn 200 - C. voice register global
default mode
no allow-hash-in-dn
max-dn 100
max-pool 200 - D. voice service voip
default mode secure
address hiding
allow-connections sip to sip
sip registrar
Answer: A
NEW QUESTION # 55
Which configuration must an administrator perform to display Translation Pattern operations in Cisco Unified Communications Manager SDL traces?
- A. Set up the Digit Analysis Complexity in Service Parameters for Cisco Unified CM to TranslationAndAlternatePatternAnalysis.
- B. Enable the Detailed Call Analysis option under Enterprise Parameters for Unified CM.
- C. Check the Translation Patterns Analysis check box in Micro Traces on the Cisco Unified CM Serviceability page.
- D. By default, the Translation Patterns operations are printed in SDL traces, so no additional configuration is necessary.
Answer: B
Explanation:
Reference:
https://community.cisco.com/t5/collaboration-voice-and-video/taking-sip-call-trace-on-cisco-unified- cm-using-rtmt/ta-p/3161200
NEW QUESTION # 56
Refer to the exhibit.
A user dials 84969010 and observes that the call is not routed immediately. The administrator notices that after matching the fixed-length translation pattern, the call hits the \+! pattern and waits for interdigit timeout What should be configured to ensure that the call routes out immediately?
- A. Allow Device Override on the route pattern
- B. Do Not Wait For Interdigit Timeout On Subsequent Hops on the route pattern
- C. Route Next Hop By Calling Party Number on the translation pattern
- D. Do Not Wait For Interdigit Timeout On Subsequent Hops on the translation pattern
Answer: D
NEW QUESTION # 57
The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses H.323 protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real- Time Transport Protocol traffic that had the one-way audio call.
You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).
- A. H.245 Open Logical Channel Ack
- B. H.245 Open Logical Channel
- C. H.245 Terminal Capability Set
- D. H.225 Connect
Answer: B
Explanation:
Reference:
http://ccievoicehopeful.blogspot.com/2012/09/h323-notes.html
NEW QUESTION # 58
Which elements does Cisco cloud mobility for collaboration include?
- A. Cisco Collaboration Cloud
- B. Cisco Collaboration Cloud and Cisco Webex Collaboration Cloud Services
- C. Cisco Collaboration Cloud and Cisco Mobile and Remote Access Collaboration Cloud Services
- D. Cisco Webex Collaboration Cloud Services
Answer: C
NEW QUESTION # 59
An engineer needs to deploy Cisco Extension Mobility. The engineer already activated the required services, configured the Extension Mobility Phone Service, and created an Extension Mobility device profile that is associated with end users. Which two additional steps are required to complete the configuration? (Choose two.)
- A. Subscribe the device profile to the Extension Mobility Phone Service.
- B. Subscribe IP phones to the Extension Mobility Phone Service.
- C. Subscribe directory numbers to the Extension Mobility Phone Service.
- D. Consolidate Cisco UCM certificates by using Bulk Certificate Management.
- E. Define the default Device Template on IP phones when users log out.
Answer: A,E
NEW QUESTION # 60
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?
- A. in Cisco Unified CM Enterprise Parameters
- B. in the telephony service configuration
- C. in Cisco Unified CM Service Parameters
- D. in the queuing configuration
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications- manager-callmanager/200453-Configure-CUCM-Native-Call-Queuing-Featu.html
NEW QUESTION # 61
When you troubleshoot H.323 call setup, which message informs you that the called party is being notified about the call?
- A. ALERTING
- B. CONNECT
- C. RINGING
- D. PROCEEDING
Answer: B
NEW QUESTION # 62
After configuring a Cisco CallManager Express with Cisco Unity Express, inbound calls from the PSTN SIP trunk receive a ring tone for 20 seconds and then a busy signal instead of voicemail.
Which configuration fixes this problem?
- A. Router(config)# voice service voip
Router(conf-voi-serv)#allow-connections h323 to h323 - B. Router(config)# voice service voip
Router(conf-voi-serv)#no supplementary-service sip moved-temporarily - C. Router(config)# voice service voip
Router(conf-voi-serv)#allow-connections voice-mail mod - D. Router(config)#dial-peer voice 2 voip
Router(config-dial-peer)#no vad
Answer: B
Explanation:
https://community.cisco.com/t5/ip-telephony-and-phones/help-please-callers-get-busy-signal- instead-of-aim-cue-voicemail/td-p/1911590
NEW QUESTION # 63
Refer to the exhibit.
In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user C.
Which two scenarios are correct? (Choose two.)
- A. Phone_A sends a SIP-REFER message to the Cisco Unified Communications Manager with Phone_C information in the Refer-To section.
- B. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the music on hold and the MOH audio is chosen from Phone_A Network Hold MOH Audio Source settings.
- C. Phone_B sends a SIP-REFER message to the Cisco Unified CM with Phone_C information in the Refer-To section.
- D. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_A User Hold MOH Audio Source settings.
- E. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_B User Hold MOH Audio Source settings.
Answer: A,E
NEW QUESTION # 64
......
To be eligible for the exam, candidates must have a valid Cisco CCNP Collaboration or CCIE Collaboration certification. They must also have a minimum of three years of experience in designing, deploying, and managing Cisco collaboration and communication solutions.
Pass Your Next 300-815 Certification Exam Easily & Hassle Free: https://prep4sure.real4dumps.com/300-815-prep4sure-exam.html
